Posts

Wing section 13 - Main Spar

Image
 Section 13 was a lot about counter sinking and nut plates. I didn't take many pictures. J channel are match drilled against the main spar assembly, but they are used on the top skin. It took me a while to understand that for some reason.   I got some help from my wife on the counter sinking task. Instead of point priming the material revealed after counter sinking, i primed the whole flange. 14 Wing Ribs I've already started on next section. A few pictures below.

Wing kit has arrived

Image
The wing kit arrived on Friday (9th October) and today was used to inventory the two boxes. Even though the two boxes had been on a 2 month journey, they were undamaged. A few item was missing, but will hopefully show up soon. One piece J Channel longs was missing, and that one is needed already in the first section. But it's possible to use a short J channel instead. Also the W-1025B-R FLAP HINGE RIB is i bit critical for the progress as it needed in the section 14.

Section 38 Canopy and Window

Image
The canopy is now more or less finished. Gaskets, wiring and connectors, and final fitting will be done later. This section has been lengthy with around 170 hours. Not so bad after a layer of primer, but there is still a bit more sanding to do. And perhaps some filler as well.

Update: Canopy and Window almost done, wing kit a bit delayed

Image
Section 38 is coming to an end. Today I epoxied the canopy to the canopy assembly, and will be a couple of iteration with sanding and filling. The wing kit is a bit delayed, and will arrive in Oslo 28th September. The container didn't get loaded on the correct ship😕 First fitting of the aft canopy The aft canopy has to be cut to align with the roll bar. After trying different approaches, I ended up with the Dremel diamond cutting wheel. Ready for drilling. I had to do some touch up on the interior paint.  The businh doubler painted and the latch link is painted. Initial test of the canopy frame. Then with the canopy attached. The compass and the Garmin GI-260 AOA (angle of attack) indicator trial fit. Yepp. It works. Painting  the inside of the canopy assembly in battleship grey as the rest of the interior. Ready for glareshield painting.  The result turned out great, after a few layers. I started with Stewart System midnight black with flatenner. But I was happy with it...

Electrical wiring

Image
 All fuselage wiring is now done. Only exception is the COAX to the right wing nav antenna. That one will go all the way and not through the wing root connector. So I will install that at at later stage, so I don't have a large loop of coax hanging in the right wing root area. It took more time than anticipated, but at the same time i updated and amended the documentation in a spreadsheet. Also a bit of research had to be done and things had to be decided. It gets very crowded in the keel. This is the the 2 coax for the GPS antennas. The left forward is the GA-35 for the GTN 650, and the right one is GA-57X for the G3X. This is the stick cable. I used 2 pc. 4 wire shielded cable for each stick. The shield is not necessary, but it was convenient to use the shield as one "wire". I then have a total of 10 wires to each stick. Trim up/down/left/right, PTT (push to talk), AP disconnect, Flap up/down, pluss to wires for common gnd. I can use the 2 common to individually disconn...